Upload cura profile 1
|
Upload cura profile 2
|
Opening uploads/horn.curaprofile
This is in development
Parameter |
Default fdmprinter Value |
Profile 1 base
| Profile 1
| Profile 2 base
|
Profile 2
|
Label |
Description |
layer_height | 0.1 | - | 0.1 | - | - | Layer Height | The height of each layer in mm. Higher values produce faster prints in lower resolution, lower values produce slower prints in higher resolution. |
version | - | 4 | 4 | - | - | | |
name | - | empty | empty | - | - | | |
definition | - | artillery_base | artillery_base | - | - | | |
type | - | quality_changes | quality_changes | - | - | | |
quality_type | - | standard | standard | - | - | | |
intent_category | - | default | - | - | - | | |
setting_version | - | 22 | 22 | - | - | | |
Dump fdmprinter